lilmule
Registered user
Registered: 04-2010
Location: Buchanan,Tn
Posts: 201
|
|
Reply | Quote
|
|
Solution to the 13 spline limited selection of props
Just ordered a flo torque 2 hub kit for older omc motors now all those tro4 and quicksilver porps are added to the selection,cost 30 bucks new off ebay.
---
|
|
Sep/10/2010, 10:41 pm
|
Link to this post
Email lilmule
PM lilmule
|
wevel2
Moderator
Registered: 04-2010
Posts: 352
|
|
Reply | Quote
|
|
Re: Solution to the 13 spline limited selection of props
good buy.. now u can run a whole bunch of props have fun testing let us know ur speed numbers im interested in seeing what ya get on the ally
---
its almost done..wait... awl he!!..it will never be done
|
|
Sep/10/2010, 11:48 pm
|
Link to this post
Email wevel2
PM wevel2
|
lilmule
Registered user
Registered: 04-2010
Location: Buchanan,Tn
Posts: 201
|
|
Reply | Quote
|
|
Re: Solution to the 13 spline limited selection of props
Also picked up a 24 P raker 13 fixed spline just for a test(cheap)
---
|
|
Sep/11/2010, 8:08 am
|
Link to this post
Email lilmule
PM lilmule
|
wevel2
Moderator
Registered: 04-2010
Posts: 352
|
|
Reply | Quote
|
|
Re: Solution to the 13 spline limited selection of props
shouldve let me know ya wonted to run a 24 raker i have one ida let go its got some cupping ( not good cupping i might add) and edeges sharpened and ballanced im guessing u just wanted some rpm details once again keep us informed on the speed setup.
---
its almost done..wait... awl he!!..it will never be done
|
|
Sep/11/2010, 5:56 pm
|
Link to this post
Email wevel2
PM wevel2
|
lilmule
Registered user
Registered: 04-2010
Location: Buchanan,Tn
Posts: 201
|
|
Reply | Quote
|
|
Re: Solution to the 13 spline limited selection of props
Well was surfing looking for a 23 p chopper,ran into it on ebay and placed a min bid and got it 5 days later,as for what speed your getting suspect while i have an alley be hard to duplicate as you are lighter and less length,your boat was built for just that engine almost.While mine generally runs good with less wasnt designed with that in mind.
My own estimates I hope hold up guessing 60-62 when propped correct.Wont be able to raise it in the begining until I get a tap and install psi fitting,not taking any chances with a motor that one cannot see pea,from in front of it,and barely when behind it.
On a 135 I had many years ago an over the hub 23 mazco ran better than anything else I ever got ahold of.Yet really needed more cup.
---
|
|
Sep/17/2010, 7:46 pm
|
Link to this post
Email lilmule
PM lilmule
|
